elongation

来源:学生作业帮助网 编辑:作业帮 时间:2024/05/05 01:11:56
elongation

elongation
elongation

elongation
elongation avg
延长率
释义
1.
延长率
机械类综合 - 工程英语 - CADSALON 沙龙论坛... ... Selenium 硒Elongation Avg . 延长率 creepage distance 爬电距离 ...

elongation butt elongation 是什么 strength and elongation是什么意思 This cell wall elongation is accomplished in a mycelial fashion,i.e.,polarly 怎么翻译? 英语翻译01-04-0319/0320-GA Mount Rear Suspension LH/RH - 1 each per amphibian Aluminum:250 MPa yield,310 MPa ultimate,7% elongation 英语翻译Gibberellins are a class of endogenous phytohormones that regulate a wide range of developmental processes in plants,including germination ,stem elongation,and flower development . 英语翻译The DNA was amplified with 32 cycles using the following conditions:preheating to 95◦C for 5 min,denaturation at 95◦C for 30 s,annealing at 55◦C for 30 s,elongation at 72◦C for 1 min and a final elongation step at 英语翻译Hucka and Das stated that the concept of brittliness was not yet made precise.But with higher brittleness,the facts are observed,which include low values of elongation,fracture failure,formationoffines,high ratio of compressive to tensile 请问什么是张应力When the stretching direction is perpendicular to the direction of constant tensile stress,elongation of the films was observed under light irradiation.In contrast to the perpendicular case,the contraction of the films was obs 10 s at 92°C,30 s at 65°C,and 13 min at 68°C 1 cycle elongation of 20 s for each cycle怎么翻译 英语翻译Both the strength and uniform elongation of a bi-modal Cu can adhere to the rule of mixtures,这句话关键是 “adhere to the rule of mixtures”不会翻, 这是什么牌号的钢材,C % :0.04 max Si% :0.30 max Mn% :0.25 0.5 S% :0.050 max P% :0.045 max Ni% :0.30 max Cr% :0.30 max Cu% :0.30 max N% :0.0080 max UTS (MPa) :300 TO 540 Upper Yield Stress (Mpa) :185 min Elongation after fracture (%) :18 请问这个是什么板材、或者说什么钢材?Tensile Strength (Mpa) 抗拉强度:600 720Yield Point 屈服点 – mín.(MPa):最小 460Elongation (Plates) 延伸率:In 2 Inches (50 mm),min,(%) 19Composition 成分:Carbon,max.碳(%):0,16 英语翻译The properties we require are as follows,pls.see if this is within your specifications and if you would be able to supply a quotation:Polyester:77%Spandex:23%Elongation:min 150% max 180%Modulus:min 1300g max 1500g.(特别这个不懂他